What will happen if you do not maintain it on time

The increase of the operating load of the main engine causes harm to the main motor and electrical system. The strong friction that may occur between the main screw, between the screw and the front and back end faces, and between the screw and the host housing will cause the operating load of the main engine to increase sharply, and the operating load of the seriously worn bearing is also very large. In this way, the motor is in an overload working state, which will seriously endanger the safe operation of the motor. If the situation is serious, if the electrical protection device of the air compressor unit is insensitive or ineffective, it may also lead to the motor burning.

2, the air compressor exhaust volume will occur a large attenuation.

The increase of the mating gap of the main engine will lead to a serious reduction in the efficiency of the main engine, that is, the air compressor exhaust volume will decay greatly, which will have a certain impact on the normal production of the gas unit. Especially for those users who have a small amount of air compressor exhaust configuration, due to the attenuation of air compressor exhaust, in the case of relatively stable gas consumption of the gas system, the compressed air pressure of the pipe network will be reduced a lot, and the gas system equipment may not work normally or cannot work at all, which affects the normal production of the unit or leads to temporary production suspension, and brings losses to the enterprise.

3, the serious consequence is that there will be a sudden "hug" of the host.

Once such a situation occurs, if the electrical protection system is not responsive or fails to protect, it may also bring serious damage to the main motor and electrical system.

For the host "holding" processing, on the one hand, the maintenance cost of overhaul will be much more expensive than normal overhaul, on the other hand, because the host components will be damaged, so the overall performance of the repaired host will be worse than the normal overhaul of the host. If the severity of the damage to the host has reached the point where it has no repair value or cannot be repaired at all, it can only be scrapped and replaced with a new host, and the direct loss is very large. Because the cost of the new host is usually about one-third of the cost of the entire air compressor, much higher than the cost of the main host overhaul under normal circumstances, and under normal circumstances the comprehensive technical performance of the qualified host and the new host is very similar!

Normal host overhaul work is not only the basic requirements of equipment maintenance, but also the basic requirements of enterprises to control normal equipment maintenance costs, avoid unnecessary capital losses and ensure normal production of enterprises!